Bulk Lithium Polymer Drone Battery – OID 5000mAh 75C 3.7V 1S LiPo Pack (160A Continuous) for FPV & RC Models

The OID7548145-5000-3.7V-75C is a 1S lithium polymer drone battery manufactured by Jianheng (Shenzhen Jianheng Technology Co Ltd) for buyers who need dependable high-discharge power in volume. As a bulk lithium polymer drone battery option, it pairs a 5000mAh nominal capacity with a 75C rating and 160A maximum continuous discharge, making it suitable for FPV racing, RC aircraft, helicopters and other high-drain models.

Charge with a quality LiPo charger in CC/CV mode. The standard rate is 2.5A (0.5C) to 4.2V, followed by constant voltage until current falls to 0.05C or below. The maximum charge rate is 15A (3C). Never exceed 4.2V and never charge below 0°C. Use a balancing charger where multiple cells are involved.

Yes. The OID 5000mAh 75C battery supports 160A continuous discharge down to a 3.0V cutoff, with up to 200A permitted for peak loads of 3 seconds or less. Confirm that your model, connectors and wiring are rated for such high current before use.

Keep it at 0°C to 35°C and no more than 75% relative humidity, at roughly 30-60% state of charge (3.7V to 3.9V). Recharge every three months to hold the voltage window, and avoid storing the pack either fully charged or fully discharged.

Under standard cycling at 2.5A charge and discharge to 4.2V and 3.0V, the battery keeps more than 80% of its initial capacity after 300 cycles. Correct charging and storage practice help extend service life.

The specification sheet does not list specific certifications. The battery is built to meet standard safety requirements for vibration, drop testing and temperature performance. Contact Jianheng for certification documentation required for your market.

Discharge is permitted down to -20°C, though capacity drops, to approximately 70% at -10°C. Charging is only allowed between 0°C and 60°C to prevent damage.

For technical support and bulk enquiries, contact Jianheng: alan@liion-batt.com | Tel: 0086 137 2555 9416 | Address: 20F 2# Bld. Zhenhuan Rd. Pingshan, Shenzhen, China.

This LiPo pack includes overcharge, over-discharge, and short-circuit protection via proper usage. However, you must avoid physical damage, reverse polarity, direct soldering on the cell, or use near fire/heating sources. Always store at 3.7V-3.9V when not in use for long periods.