The OID7379186-16000mAh-22.2V-30C-0105 is a 6S lithium polymer Drone Battery pack made for high-current UAV platforms. It provides 22.2V nominal voltage and 16000mAh nominal capacity. The pack is fitted with an XT-90S discharge connector and a JST-XH-7P reverse-direction charging connector. Its assembly includes a black heat-shrink sleeve, magic strap, and outer transparent PVC wrap. This high-rate UAV battery pack is aimed at professional aerial work such as agricultural plant protection drones and other demanding UAVs that need stable high-rate output.
| Parameter | Value | Note |
|---|---|---|
| Charge Cut-off Voltage | 25.2V | Cell voltage less than 4.25V |
| Nominal Voltage | 22.2V | |
| Discharge Cut-off Voltage | 18.0V | |
| Nominal Capacity | 16000mAh | At 0.5C discharge |
| Minimal Capacity | 15900mAh | At 0.5C discharge |
| Standard Charging Method | 0.5C CC charge to 25.2V, then CV 25.2V until charge current declines to less than or equal to 0.02C | |
| Max Charge Current | 3.0C | At 23 plus or minus 5 degrees C |
| Continuous Discharge Current | 70A | Determined by plug and wire; battery cells can be up to 240A |
| Peak Discharge Current | 90A | Determined by plug and wire; battery cells can be up to 480A |
| Operating Temperature - Charging | -10 degrees C to 40 degrees C | |
| Operating Temperature - Discharging | -20 degrees C to 55 degrees C | |
| Initial Impedance | Less than or equal to 15mOhm | Internal resistance measured at AC 1KHz after 50 percent charge |
| Weight | About 2100g | |
| Storage Temperature - 1 Month | -20 degrees C to 40 degrees C | At shipping status: approx. 50 percent capacity of fully charged state |
| Storage Temperature - 3 Months | -10 degrees C to 35 degrees C | At shipping status: approx. 50 percent capacity of fully charged state |
| Storage Temperature - 1 Year | 22 degrees C to 28 degrees C | At shipping status: approx. 50 percent capacity of fully charged state |
| Storage Maintenance | The battery should be charged once every 3 months, keep its charge state at about 50 percent | |
| Voltage Difference | Less than or equal to 50mV per 30 days | To spurt the code date shall prevail |
| Shipment Voltage | Greater than or equal to 23.1V | |
| Battery Model | P1174170S4 | |
| Cell model Configuration | 6S | |
| Discharge Connector | XT-90S female connector, UL3135# 10AWG, exposed wire length 150 plus or minus 10mm | |
| Charging Connector | JST-XH-7P reverse-direction waterproof plug, UL3239# 22AWG, exposed wire length 150 plus or minus 10mm | |
| Packaging | One-side wiring, black heat-shrink sleeve, English label, magic strap, outer transparent PVC wrap |
| Item | Value | Tolerance | Note |
|---|---|---|---|
| Thickness (T) | Less than or equal to 73mm | Battery pack thickness | |
| Width (W) | Less than or equal to 79mm | Battery pack width | |
| Height (H) | Less than or equal to 186mm | Battery pack height | |
| Weight | About 2100g | ||
| Discharge Wire Length | 150 plus or minus 10mm | plus or minus 10mm | XT-90S female connector, UL3135# 10AWG |
| Charging Wire Length | 150 plus or minus 10mm | plus or minus 10mm | JST-XH-7P reverse-direction waterproof plug, UL3239# 22AWG |
| Item | Condition | Result |
|---|---|---|
| Capacity | According to the charge by standard method 2.6, 0.5C discharge to 18V cut-off voltage | Greater than or equal to 15900mAh |
| Cycle Life | Charge: 1C to 25.2V (cell voltage less than 4.25V); Discharge: 5C to 19.8V; 80 percent or more of 1st cycle capacity at 0.5C discharge | Greater than or equal to 500 cycles |
| Self-discharge | According to the charge by standard method 2.6, stored at 23 plus or minus 5 degrees C for 30 days, then measured capacity with 0.5C till 18V | Residual capacity greater than 90 percent |
| Temperature Characteristics - -10 degrees C | Charged by standard method 2.6, discharged at 0.5C to 18V at different temperatures; percentage based on discharge capacity at 23 degrees C | Capacity retention greater than or equal to 80 percent |
| Temperature Characteristics - 0 degrees C | Charged by standard method 2.6, discharged at 0.5C to 18V at different temperatures; percentage based on discharge capacity at 23 degrees C | Capacity retention greater than or equal to 85 percent |
| Temperature Characteristics - 50 degrees C | Charged by standard method 2.6, discharged at 0.5C to 18V at different temperatures; percentage based on discharge capacity at 23 degrees C | Capacity retention greater than or equal to 95 percent |
| High Temperature Performance | Charged by standard method 2.6, placed at 55 plus or minus 2 degrees C for 4 hours, then discharged at 0.5C to 18V | Capacity recovery rate greater than or equal to 85 percent (based on nominal capacity); thickness less than or equal to 10 percent |
| Vibration Test | Charged by standard method 2.6, fixed to vibration table, frequency varied at 1Hz per minute between 10Hz and 55Hz, excursion 1.6mm, vibrated for 30 minutes per axis of XYZ axes | No fire, no leakage |
| Drop Test | Charged by standard method 2.6, dropped from 1 meter height onto 20mm thick hard board, X, Y, Z positive and negative directions (six directions), free fall once per direction | No fire, no leakage |
| Over-discharge | Charged by standard method 2.6, discharged at 1C to 0V | No fire, no leakage |
| Over-charging | Battery with thermocouple placed in fume hood, connected to constant current and constant voltage source, adjusted to 1C2A, voltage set to n times 4.5V, charged until battery voltage is n times 4.5V and current drops to near 0A; experiment ended when battery temperature drops to about 10 degrees C below peak | No fire, no leakage |
Jianheng warrants the OID7379186-16000mAh-22.2V-30C-0105 battery pack to be free from defects in materials and workmanship under normal use and service for 12 months from shipment. Coverage requires that the battery is used, charged, and stored according to this specification. The battery must not be disassembled, modified, physically abused, immersed in water, or repaired without authorization. Damage caused by improper charging, over-discharge, over-current, external short circuit, or use beyond the stated operating limits is excluded. Jianheng may repair or replace the defective product at its discretion and is not liable for incidental or consequential damages resulting from use of this product.
Q: What charging method is recommended?
A: Use 0.5C CC charge to 25.2V, then CV 25.2V until charge current declines to less than or equal to 0.02C. The maximum charge current is 3.0C at 23 plus or minus 5 degrees C. Always use a special charger designed for this specification.
Q: What are the maximum continuous and peak discharge currents?
A: Continuous discharge current is up to 70A and peak discharge current is up to 90A, determined by plug and wire. The battery cells can support up to 240A continuous and 480A peak.
Q: How should the battery be stored for long periods?
A: For long-term storage, keep the battery at 23 plus or minus 5 degrees C and humidity of 65 plus or minus 20 percent RH. The voltage should be 21.6V to 23.4V. Charge the battery once every 3 months and keep it at about 50 percent charge state. The storage temperature range is -20 degrees C to 40 degrees C.
Q: What is the cycle life?
A: Cycle life is greater than or equal to 500 cycles with capacity retention of 80 percent or more under the specified test conditions: charge at 1C to 25.2V and discharge at 5C to 19.8V.
Q: Which safety tests does the pack pass?
A: The pack passes vibration, drop, over-discharge, and over-charge tests without fire or leakage. Its PCM provides overcharging prevention, over-discharging prevention, and over-current prevention.
Q: What connectors are used?
A: The discharge connector is an XT-90S female connector with UL3135# 10AWG wire and exposed wire length 150 plus or minus 10mm. The charging connector is a JST-XH-7P reverse-direction waterproof plug with UL3239# 22AWG wire and exposed wire length 150 plus or minus 10mm.
Q: What is the shipment voltage?
A: The shipment voltage is greater than or equal to 23.1V.
Q: What certifications are available?
A: The battery is certified with UN38.3 and MSDS.
The battery pack shall be stored within -20 degrees C to 40 degrees C. For long-term storage (more than once every three months must fill the electricity), the environmental condition should be: temperature 23 plus or minus 5 degrees C, humidity 65 plus or minus 20 percent RH. The voltage for long-term storage shall be 21.6V to 23.4V. The battery should be charged once every 3 months and kept at about 50 percent charge state. During transportation, the battery should be kept away from water, fire sources, and strong impacts. The product should be packed properly to prevent short circuits and mechanical damage. The shipment voltage is greater than or equal to 23.1V.